Sells Mendel 201105

Printer Notes

According to http://makergear.wikidot.com/prusa setting for retraction: Plastruder retraction settings: 18mm/m and 1.3mm length According to https://reprap.org/wiki/Volumetric_Dimension_settings setting for extrusion: MakerGear Mendel Prusa kit: 1258 step/mm experimentally found by moving 100mm and 500mm --Affy, May 15th, 2012

Progress on Sells Mendel as of 20120302

Paul Brown printed and installed a new X Carriage. It works fabulously well, and also allows the use of the Budaschnozzle v1.0 hot-end.

Progress on Sells Mendel as of 20111103

Printed and installed the Afterthought Foot.

• Mendel 201105
• 
• 
• 

Installed the Makergear Stepstruder at some point last week, and have been testing and calibrating since. It is working great! https://www.makergear.com/products/extruder-motor?variant=21668418500

• Mendel 201105
• 
• 

Progress on Sells Mendel as of 20111005/20111006

Getting the Mendel back up and working. Software is working. Firmware is compiled and installed. Heated build platform is working (mostly.) Only thing remaining is getting the extruder working.

• Mendel 201105
• 
• 
• 
• 

Progress on Sells Mendel as of 20110514/20110515

• Mendel 201105
• 
• 

Progress on Sells Mendel as of 20110510/20110511

• Mendel 201105
• 
• 

Progress on Sells Mendel as of 20110506/20110507

• Mendel 201105
• 
• 

Progress on Sells Mendel as of 20110505/20110506

• Mendel 201105
• 
• 
• 
• 
• 
•