Makerbot 797

Information about Makerbot Number 797

Physical

• Cupcake CNC Number 797 Batch XI(11)
• Reprap Motherboard v1.2, Reprap Generation 3 electronics
• Extruder Controller v2.2, Reprap Generation 3 electronics
• (Heater) Relay Board v1.0
• Plastruder MK6
  • Stepper Motor Driver v3.3 — Install doc
• Opto Endstops (non-functional at this time)
• 1 Non-heated build platform countersunk screws
• 1 Non-heated build platform non-countersunk screws
• 1 Heated build platform

Software Settings Notes

• X Backlash is currently 0.1mm
• Y Backlash is currently 0.11mm Note that the Y belt may need to be tightened to maximum tension from time to time
• Optimal PLA temp is 205C
• Optimal ABS temp is 220C

Misc

• Also see Makerbot_CupCake_CNC_3D_Printer

Planned Modifications

$212:

• Mechanical
  • Mendel inspired x and y carriage lowrider Also see Makerbot blog post.
• Electronic
  • $85 Lulzbot Sanguinolulu
  • 4 X $13 Pololu
• Hot-end
  • $75 Lulzbot Budaschnozzle